I've been a tech for Dish Network for 12 years & Directv for 3 years. I also was a Paratrooper (509th)...
639,656,704,753 and 7613 comments
Relax, I'm here to help!
this should give you the codes. to enter it just press and hold the aux button until all mode buttons flash. now type in the code and press # you should be good to go.
Long time Dish CSR and life long satellite and home theater enthusiast.
Check http://www.mydish.com/support/apps/remotecodes.... to find the codes. Be sure to rate the codes if they work. They are programmed by Folowing this procedure:
Hold down Aux button down until all status lights at the top illuminate. Press 2 and then the three digit code listed on the Dish website, followed by the # sign. Try the volume to see if it works. If not, try the next code.
If none of the codes work, you can try a code scan using this procedure: http://www.mydish.com/support/program-to-tv-sca...
I also recommend following the procedure at the end of that list to get the code back out of the remote so you can write it down just in case you need it later.
Lastly, if none of these work, you can try to teach the remote if you have a 20.x, 21.x, 32.x or 40.x remote. Follow these instructions: http://www.mydish.com/support/teach-learning-re...