Ask a question – describe your problem in detail.

Get help from experts on:
    more options

3 minutes

Average Response Time

How do I program dish remote to a sony wega tv ?

How do I program dish remote to a sony wega tv ?
Rick asked this question 2 years ago
  • Dish Network • 1314 answers • 89% helpful

    Accepted answer
    all sony's work with the same code. press and hold sat button until all mode buttons light up. press 5 0 0 # and wait for everything to stop blinking. now press the sat button and you are good to go
    4 comments
  • Dish Network • 635 answers • 91% helpful

    Press the clear TV button on the top of your remote until all the clear lights on top lite up. then press 5 0 0 (five zero zero) on your number pad then press the # button on the bottom of the remote. TV lite should blink three times if successful.
    Hope this helps.
    1 comment
  • Dish Network • 1177 answers • 95% helpful

    If that does not work try power scan hold clear Tv button until lights light up press red Tv button and the up button repeatly until Tv goes off when it does press down button and record
    3 comments
  • Dish Network • 1531 answers • 85% helpful

    press and hold "TV" button at the top of remote till all 4 lights come on. now perss and release the power button now press channel up repedatly when tv turns off, press the # button. (Sony is usually the 1st press of the chan up button)
    7 comments
    • R
      Rick
      Thank you
    • R
      Rick
      Thank you
    • Dish Network • 1531 answers • 85% helpful

      no problem, did it work?
    • R
      Rick
      Yes it did, ty. But it would not work on my other (Sanyo hd). Any suggestions ?
    • Dish Network • 1531 answers • 85% helpful

      there are over 200 codes built into the remote keep pressing the Up button (about a 1 second pause between presses)
    • Dish Network • 1531 answers • 85% helpful

      or follow prophets directions and use one of these sanyo codes one at the time until you find one that works.
      542, 590, 652, 683
    • Dish Network • 1531 answers • 85% helpful

      or try prophets suggestion using sanyo codes 542, 590, 652, 683
  • Dish Network • 14429 answers • 94% helpful

    Grab ur dish remote. Point it at the tv. Press & hold the tv button at the very very top till all 4 lites lite up. Them press the big red power button once. Now press the channel up slowly till ur tv turns off. Once it does press the pound (#) once. Now turn ur tv back on pressing the big red power button 3 to 5 times or until ur tv comes back on. Hope this helps. :)
  • Dish Network • 905 answers • 95% helpful

    turn your tv on

    take dish remote

    hold the TV button till all the lights on top flashes
    push 500
    push #
    now test volume

    it is now programmed.