I'll cant program my sony tv to my dish remote
-
Field Service Specialist IV
9 + years
turn your tv on
take dish remote
hold TV button till all the lights on top flashes
push 500
push #
your tv button should flash 3 times
now test your volume
it is now programmed.0 comments2 other experts are backing this answer
-
Super Dish Installer
Trouble Shooting issues? no problem i can help u with almost anythin.
Ok on the dish remote push and hold the SAT clear button until all the lights come on then let go and push 500 and the pound key #. You must do this on a quick sequence
-
Dish Network
Dish Network field serivce manager.
the code for your remote is 500, hold the TV button at the very top of the remote down until the top buttons all light up. the push the push 500 then # after it blinks 3 times then try to volume
-
SuperAIRBORNEMan
I've been a tech for Dish Network for 12 years & Directv for 3 years. I also was a Paratrooper (509th)...
Press & hold the tv button at the very very top till all 4 lites lite up. Then press the big red power button. Then press the channel up button slowly till ur tv turns off. When it does press the # button. Then press the big red power button 3 to 5 times or until ur tv comes on. That's it.
-
tivosat
expert trainer Dish Network http://www.directly.com/in/tivosat-4 tivosat@hotmail.com 15 year Airforce...
1. Press and hold “tv” button at the top of the remote till all the lights come on (about 4 seconds)
2. Enter 500 then press # (tv button will flash 3 times)
3. Press power button. If tv turns off you are done, if not repeat steps with a different code. Be sure to check other functions to make sure they work. If they don’t, try other codes. -
prophet
Relax, I'm here to help!
follow the directions above with the code 500. works like a champ
